Step 51 - 60

DISASSEMBLY

NOTE: If transaxle is being overhauled (clutch and/or seal replacement) or replaced, it is necessary to perform the PCM/TCM Quick Learn Procedure Testing and Inspection.

NOTE: This procedure does not include final drive (differential) disassembly.





51. Bend output gear retaining strap (1) ears flat to allow bolt removal.
52. Remove output shaft stirrup strap bolts (3).




53. Remove stirrup (3) and strap (2).




54. Using Holding Tool 6259 (2).




55. Remove output shaft gear-to-shaft bolt (2)and washer (3).




56. Using Gear Puller L4407A, (4) and button 6055 (2), remove output gear (1) from shaft.




57. Remove output gear bearing shim (select) (2).




58. Using Puller Set 5048 with jaws 5048-5 and button L-4539-2 (1) Remove output gear bearing cone.




59. Remove rear carrier assembly (1) from transaxle.




60. Remove rear carrier assembly (3) bearing cone using Puller Set 5048 with jaws 5048-3 and button 6055.