Operation CHARM: Car repair manuals for everyone.
Home >> Dodge and Ram >> 2008 >> Magnum V8-5.7L >> Repair and Diagnosis >> Starting and Charging >> Charging System >> Alternator >> Service and Repair >> Generator - Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Generator - Installation







5.7L





1. Position generator (2) to engine and loosely install 2 mounting bolts (1).




2. Position support bracket (1) to generator and loosely install bolt (3) and nut (4).
3. Tighten generator mounting bolts to 65 Nm (48 ft. lbs.).
4. Tighten bracket nut (4) to 28 Nm (20.5 ft. lbs.).
5. Snap field wire connector into rear of generator.
6. Install B+ terminal eyelet to generator output stud. Tighten nut to 13 Nm (115 in. lbs.).




7. Position transmission cooler line (2) and install transmission cooler line clamp bolt (1) to right crossmember (3).
8. Install lower splash shield.
9. Lower vehicle.

CAUTION: When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat.

10. Install generator drive belt Accessory Drive Belt - Installation.
11. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).
pro multis · About Operation CHARM