B219F

B219F IGNITION OFF DRAW (IOD) FUSE BLOWN

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
With the ignition on. This DTC will only set if vehicle has over 50 miles on it.

- Set Condition:
IOD Fuse not installed or blown.






Diagnostic Test

1. CHECK FOR ACTIVE DTC
With the scan tool, record and erase DTC's.
Cycle the ignition switch from off to on, leaving the ignition off for a minimum of 30 seconds.
With the scan tool, read the active DTC's.
Does the scan tool display this DTC as active?

Yes

- Go to 2

No

- If the DTC is stored, check for an intermittent condition. Using the wiring diagram/schematic as a guide, visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.

2. IOD FUSE
Verify IOD Fuse installed in TIPM.
Is IOD Fuse present?

Yes

- Go to 3

No

- Replace the IOD Fuse.
- Perform BODY VERIFICATION TEST VER 1. Body Verification Test

3. IOD FUSE BLOWN
Verify IOD Fuse is blown.
Is IOD Fuse blown?

Yes

- Using the wiring diagrams, diagnose for a short to ground condition.
- Perform BODY VERIFICATION TEST VER 1. Body Verification Test

No

- Test complete.