C2100

C2100-BATTERY VOLTAGE LOW

For a complete wiring diagram Consult Diagrams/Electrical

- When Monitored:
With the ignition on.

- Set Condition:
If the Anti-Lock Brakes Module detects system voltage is below 9.5 volts.





Diagnostic Test

1. DTCS IN THE PCM
NOTE: This DTC must be active for the results of this test to be valid.

Turn the ignition on.
With the scan tool, read and record DTCs from the PCM.
With the scan tool, read and record Freeze Frame information.
With the scan tool, erase DTCs.
Start the engine.
With the scan tool, read and record DTCs.
With the scan tool read DTCs from the PCM.
Are any charging system codes present?

Yes

- Repair the charging system DTC in the PCM.
- Perform ABS VERIFICATION TEST. ABS Verification Test.

No

- Go to 2

2. CHARGING SYSTEM FAILURE
Start the engine.
Connect voltmeter to vehicle battery.
Is the vehicle battery voltage under 8.2 volts?

No

- Refer to the ABS-INTERMITTENT CONDITION TEST. ABS Intermittent Condition Test

Yes

- Repair the charging system.
- Perform ABS VERIFICATION TEST. ABS Verification Test.