Gas

U0141-LOST COMMUNICATION WITH FRONT CONTROL MODULE (TIPM)





For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
Ignition run time is greater than 1 second. Battery voltage between 9 and 16 volts.

- Set Condition:
The PCM doesn't receive a TIPM message over the CAN C circuit for 7 consecutive seconds. The circuit is continuously monitored. One Trip fault.





Refer to Communications Test for this DTC and/or Manufacturer Code Charts for diagnostic procedures and for further possible causes.

Diagnostic Test

1. ACTIVE DTC
Ignition on, engine not running.
With a scan tool, select View PCM DTCs.
Is the DTC Active at this time?

Yes

- Refer to Communications Test for this DTC and/or Manufacturer Code Charts for diagnostic procedures and for further possible causes.

No

- Refer to the INTERMITTENT CONDITION Diagnostic Procedure. Intermittent Condition