Rear

REAR





1. Install the brake pads if removed.
2. Install caliper. Tighten the bolts (6) to 37 Nm (28 ft. lbs.)

CAUTION: Verify brake hose (5) is not twisted or kinked before tightening fitting bolt.

3. Install the brake hose (5) to the caliper with new seal washers and install the brake hose banjo bolt (4) tighten fitting bolt to 31 Nm (23 ft. lbs.).
4. Remove the prop rod from the vehicle.
5. Bleed the base brake system, Brake Bleeding OR Brake Bleeding.
6. Install the wheel and tire assemblies Removal and Replacement.
7. Remove the supports and lower the vehicle.
8. Verify a firm pedal before moving the vehicle.