Second Row Outboard

SECOND ROW OUTBOARD

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler Mopar(R) Parts Catalog.

NOTE: All seat belt retractors except the driver side front and the second row center retractor include a switchable automatic locking mechanism. Description.





1. Reach through the outboard opening between the second row seat back (2) and seat cushion (6) to access and remove the nut (1) that secures the seat belt lower anchor (7) and the forward end of the outboard seat bracket (3) to the rear floor panel (5).
2. Remove the seat belt lower anchor from the stud (4).




3. Remove the trim (2) from the inner C-pillar (1). C-Pillar Trim Panel-Removal.
4. Remove the screw (3) that secures the seat belt turning loop to the upper C-pillar.
5. Remove the quarter trim panel from the inner lower C-pillar. Console Shifter Bezel - Removal.
6. Remove the screw (5) that secures the retractor (6) bracket to the lower C-pillar.
7. Remove the second row outboard seat belt (4) and retractor from the C-pillar as a unit.