Half Shaft - Installation

INSTALLATION





1. Apply a light coat of wheel bearing grease on the female splines of the inner C/V joint.
2. Clean hub bearing bore and apply a light coat of wheel bearing grease.
3. Install half shaft (1) in axle and push firmly to engage the snap ring.
4. Pull out on the steering knuckle (2) and push the half shaft (1) through the knuckle and hub bearing.
5. Install upper control arm on steering knuckle and tighten ball joint nut to specifications.




6. Align clevis (1) with lower control arm. Install lower clevis (1) and tighten nut (2) to specifications.




7. Install tie rod end (1) in steering knuckle (2) and tighten nut to specifications.
8. Install stabilizer bar link and tie rod end.




9. Install half shaft (2) hub nut (1) and tighten to specifications.