Front Door Glass - Installation

INSTALLATION





1. Install the door glass to the module opening in the door.




2. Align the latch presenter to the rear exterior handle stud.
3. Align the carrier plate (2) to the door (4).
4. Install the electrical connector (1) to the door (4) and connect the electrical connector.




5. Install the three screws (2) securing the door latch to the door shut face and tighten screws to 7 Nm (60 in. lbs.).
6. Install the one screw (1) attaching the latch present to the door shut face and tighten screw to 7 Nm (60 in. lbs.).




7. Install the 10 screws (3) to the carrier plate (2) and tighten screws to 5.5 Nm (50 in. lbs.).




NOTE: The glass should snap into place. Make sure the glass is secure to the liftplate by pulling up on the glass to verify.

8. Connect the door glass (1) to the window regulator (2) by sliding the glass down into the liftplate.
9. Apply the adhesive tape to the inspection cover in the door module.




10. Install the inner door weatherstrip Installation.




NOTE: The door glass must be in the full up position in order to access the rear exterior handle nut. Use light and a magnetic socket on the rear nut to prevent from dropping the nut into the door assembly.

11. Install the rear nut (1) to the exterior handle and tighten to 4.5 Nm (40 in. lbs.).
12. Install the door plug (2) to the door.
13. Install the trim panel to the door Front Door Trim Panel - Installation.