Removal

REMOVAL

NOTE: The washer pump/motor can be removed from the washer reservoir without removing the reservoir from the vehicle.





1. Disconnect and isolate the battery negative cable.
2. Siphon the washer fluid from the washer reservoir (1) on the left side of the cooling module in the engine compartment into a clean container for reuse.
3. Disconnect the front end module wire harness connector (3) from the washer pump/motor unit connector receptacle on the top of the motor housing (2).
4. Disconnect the two washer hoses (4 and 5) from the two washer pump/motor unit outlet nipples.
5. Firmly grasp the top of the washer pump/motor housing and pull it lightly outward from the washer reservoir far enough to disengage the top of the motor from the receptacle in the reservoir. Care must be taken not to damage the reservoir.
6. Pull the washer pump/motor unit straight up and out of the washer reservoir far enough to disengage the inlet nipple from the rubber grommet seal/filter screen in the reservoir.
7. Remove the rubber grommet seal/filter screen for the washer pump from the pump mounting hole in the washer reservoir and discard.