Wiper Module - Removal

REMOVAL





1. Disconnect and isolate the battery negative cable.
2. Remove both front wiper arms from the wiper pivots. Wiper Arms - Removal.
3. Remove the cowl plenum cover/grille panel from over the cowl plenum. Removal.
4. Disconnect the wire harness connector (6) for the front wiper motor (5) from the motor connector receptacle.
5. Remove the two screws (1) that secure the ends of the front wiper module bracket to the cowl plenum (3).
6. Remove the nut (2) that secures the front wiper motor bracket rubber insulator to the weld stud (4) located on the bottom of the cowl plenum.
7. Remove the front wiper module from the cowl plenum as a unit.