Communications

B210D-BATTERY VOLTAGE LOW - (TIPM)

For a complete wiring diagram Refer to Diagrams/Electrical.


- When Monitored:
With the ignition on.

- Set Condition:
Battery voltage less than 9 volts for more than 15 seconds.







Diagnostic Test


1. CHECK FOR ANY POWERTRAIN/ENGINE CONTROL MODULES DTCS

NOTE: Make sure the battery is in good condition. Using the Midtronics Battery Tester, test the battery before continuing.


NOTE: Inspect the vehicle for after market accessories that may exceed the Generator System output.


NOTE: Make sure the generator drive belt is in good operating condition.


NOTE: Inspect the fuses in the TIPM. If an open fuse is found, use the wire diagram/schematic as a guide, inspect the wiring and connectors for damage.

Turn the ignition on.
With the scan tool, read active PCM/ECM DTC's.
Does the scan tool display any active DTC's?

Yes


- Diagnose and repair the DTC.

No


- Check the above conditions that can cause a low voltage condition. Repair as necessary.