Installation

INSTALLATION

FREE PIVOT HINGE/COVER






NOTE: Do not reuse the seat fasteners, always replace with new ones.

1. Position the pivot hinge cover (3) over the pivot hinge (4) and install the 12v power supply harness (5 - if equipped) into the channel.




2. Close the hinge cover (1) flat and position the spacer (2) into place.
3. Align the stop pin (3) with the spacer (2) and hinge (1) and install the assembly onto the seat back.




4. Install a new pivot bolt (1) and tighten to 25 Nm (18 ft. lbs.).
5. Install the center seat back Installation .


INERTIA HINGE






NOTE: Do not reuse the seat fasteners, always replace with new ones.

1. Install the inertia hinge (3) onto the center seat back (2) and install new bolts (1).
2. Tighten the bolts (1) to 25 Nm (18 ft. lbs.).
3. Install the seat back inertia hinge covers Installation .
4. Install the center seat back Installation .