P0628

P0628-FUEL PUMP CONTROL CIRCUIT LOW





For a complete wiring diagram, refer to the Wiring Information. Electrical Diagrams
A
- When Monitored:
With the ignition on and the Fuel Pump Relay command off.

- Set Condition:
The Engine Control Module (ECM) detects a short to ground on the (K31) Fuel Pump Relay Control circuit for 2.0 seconds.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Pre-Diagnostic Troubleshooting Procedure.

1. DTC IS ACTIVE
1. Ignition on, engine not running.
2. With the scan tool, clear DTCs in the Engine Control Module (ECM).
3. With the scan tool, actuate the Fuel Pump Relay.
4. Monitor the scan tool for at least two minutes.
5. Cycle the ignition key off and on several times, leaving the ignition on for at least 10 seconds at a time.
6. Start the engine.
7. Allow the engine to reach normal operating temperature.
8. Test drive the vehicle.
9. With the scan tool, select View DTCs.

Is the status Active for this DTC?

Yes

- Go To 2

No

- Perform the INTERMITTENT DTC diagnostic procedure. . Checking for an Intermittent DTC

2. (K31) FUEL PUMP RELAY CONTROL CIRCUIT SHORTED TO GROUND




1. Turn the ignition off.
2. Remove the Fuel Pump Relay.
3. Disconnect the Engine Control Module (ECM) harness connector.
4. Measure the resistance between ground and the (K31) Fuel Pump Relay Control circuit in the Fuel Pump Relay connector.

Is the resistance below 1000 Ohms?

Yes

- Repair the (K31) Fuel Pump Relay Control circuit for a short to ground.
- Perform the ECM VERIFICATION TEST. .

No

- Go To 3

3. (K31) FUEL PUMP RELAY CONTROL CIRCUIT OPEN OR HIGH RESISTANCE




1. Measure the resistance of the (K31) Fuel Pump Relay Control circuit between the Fuel Pump Relay connector and the Engine Control Module (ECM) harness connector.

Is the resistance below 10.0 Ohms?

Yes

- Go To 4

No

- Repair the (K31) Fuel Pump Relay Control circuit for an open circuit or high resistance.
- Perform the ECM VERIFICATION TEST. .

4. FUEL PUMP RELAY
1. Connect the Engine Control Module (ECM) harness connector.
2. Install a known good relay in place of the vehicle's Fuel Pump Relay.
3. Turn the ignition on.
4. With the scan tool, clear DTCs.
5. With the scan tool, actuate the Fuel Pump Relay.
6. Monitor the scan tool for at least two minutes.
7. With the scan tool, select View DTCs.

Is the status Active for this DTC?

Yes

- Go To 5

No

- Replace the Fuel Pump Relay.
- Perform the ECM VERIFICATION TEST. .

5. ENGINE CONTROL MODULE (ECM)
1. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors between the Fuel Pump Relay and the Engine Control Module (ECM).
2. Look for any chafed, pierced, pinched, or partially broken wires.
3. Look for broken, bent, pushed out or corroded terminals.
4. Perform any Technical Service Bulletins that may apply.

Were any problems found?

Yes

- Repair as necessary.
- Perform the ECM VERIFICATION TEST. .

No

- Replace the Engine Control Module (ECM).
- Perform the ECM VERIFICATION TEST. .