Intermediate Shaft - Removal

REMOVAL

NOTE: This procedure applies to RHD vehicles only. The intermediate shaft (Z-coupling) on the LHD column is not serviceable.

1. Fully extend or pull out adjustable steering column (where applicable).
2. Position the front wheels straight-ahead. Center the steering wheel and lock it in place with a steering wheel holder.
3. Raise and support the vehicle. Service and Repair
4. Remove the parking brake lever . Removal




5. Remove the pinch bolt (3) connecting the intermediate shaft (1) to the steering coupling shaft (2).
6. Separate the intermediate shaft (1) from the steering coupling (2).
7. Lower the vehicle.





8. Remove the two retaining nuts (3) securing the intermediate shaft to the dash panel.
9. Loosen the shaft seal at the dash panel.





10. Remove the pinch bolt (3) securing the intermediate shaft to the steering column shaft (1).
11. Slide the intermediate shaft (2) off the steering column shaft (1) and remove it from the vehicle.