Crankshaft Position Sensor - Removal

REMOVAL

The Crankshaft Position (CKP) sensor is located at the right-rear side of the engine block (1). It is positioned and bolted into a machined hole in the engine block.





1. Disconnect and isolate the negative battery cable.
2. Raise and support the vehicle.
3. Remove the starter motor Starter - Removal
4. Disconnect the CKP sensor electrical connector (1).





5. Remove the CKP sensor mounting bolt (1).
6. Using a slight twisting motion, remove the CKP sensor from the engine block.





7. Check the condition of the sensor O-ring (1) and replace if necessary.