C2201

C2201-INTERNAL CONTROLLER

For a complete wiring diagram, refer to the Wiring Information Electrical Diagrams.

- When Monitored:
With the ignition on.

- Set Condition:
The Final Drive Control Module (FDCM) has detected a failure internal to the controller.





WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury
DTC IS ACTIVE
1. Ignition on, engine not running.
2. With the scan tool, read DTCs.

Is the status Active for this DTC?

Yes

- Replace the Final Drive Control Module (FDCM).
- Perform the TRANSFER CASE VERIFICATION TEST .

No

- The conditions that originally set this DTC are not present at this time.