Park Assist Display - Removal

REMOVAL





1. Disconnect and isolate the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician trained in proper HEV service safety procedures must also remove the high voltage service disconnect from the high voltage battery pack.
2. Remove the trim from the upper liftgate opening. Liftgate Trim Panel - Removal.
3. Remove the trim from both upper D-pillars. Removal.
4. Carefully pull down the rear edge of the headliner (5) from the upper liftgate opening header (2) far enough to access the rear park assist display housing (3) and the display retainer (4).
5. Disconnect the wire harness connector (1) from the connector receptacle on the left end of the display housing.
6. Carefully spread the front and rear edges of the molded plastic retainer far enough to disengage the three retainer tabs from the slots in the display housing, then lift the retainer off of the display housing.
7. Push the right end of the display out through the lower surface of the headliner, then slide the display toward the right side of the vehicle far enough to disengage the connector receptacle from the headliner opening.