Second Row

INSTALLATION

SEAT CUSHION ELEMENT





CAUTION: During the installation of the replacement heating element, be careful not to fold or crease the element assembly. Folds or creases will cause premature failure.

1. Install the new heater element by peeling off the adhesive backing and placing it directly where the factory installed heater element was.





2. Connect the heated second row seat cushion element electrical connector (2) and install the harness routing clip to the rear center floor console bracket (1).
3. Install the rear center floor consoleRear Center Console - Installation.
4. Connect the battery negative cable.
5. Verify heated rear seat system operation.
6. Install the appropriate seat cushion cover, Seat Cushion Cover - Installation.

NOTE: Make certain the seat wire harness is correctly routed through the seat and seat back. The excess wire between the cushion and back elements should be securely tucked between the rear of the cushion foam and the rear carpet flap of the trim cover.


SEAT BACK ELEMENT





CAUTION: During the installation of the replacement heating element, be careful not to fold or crease the element assembly. Folds or creases will cause premature failure.

NOTE: Second row heated seat cushion shown, second row heated seat back similar.

1. Install the new heater element by peeling off the adhesive backing and placing it directly where the factory installed heater element was.





2. Connect the heated second row seat back element electrical connector (3) and install the harness routing clip.
3. Connect the battery negative cable.
4. Verify heated rear seat system operation.
5. Install the appropriate seat back trim cover (1), Seat Back Cover - Installation.

NOTE: Make certain the seat wire harness is correctly routed through the seat and seat back. The excess wire between the cushion and back elements should be securely tucked between the rear of the cushion foam and the rear carpet flap of the trim cover.