Second Row

REMOVAL

NOTE: The factory installed heater elements can be removed from the foam cushion by carefully peeling the element off along the adhesive lines.

SEAT CUSHION ELEMENT





1. Disconnect and isolate the battery negative cable.
2. Remove the appropriate seat cushion cover, Seat Cushion Cover - Removal.
3. Remove the rear center floor console, Rear Center Console - Removal.
4. Disconnect the inoperative heated second row seat cushion element electrical connector (2) and remove the harness routing clip from the console bracket (1).
5. Remove the heater element by peeling it away from the foam cushion, being careful not to remove excessive foam in the process.

SEAT BACK ELEMENT





1. Disconnect and isolate the battery negative cable.
2. Remove the appropriate seat back trim cover (1), Seat Cushion Cover - Removal.
3. Remove the inner second row seat cushion (2) to seat back (1) bracket trim cover.
4. Disconnect the inoperative heated second row seat back element electrical connector (3) and remove the harness routing clip.
5. Remove the heater element by peeling it away from the foam cushion, being careful not to remove excessive foam in the process.