Installation - Rear

INSTALLATION





1. Position the rear blower motor resistor (1) into the rear heater-A/C housing (2). Make sure the resistor is fully engage by the retaining tab on the housing
2. Install the screw (3) that secures the rear blower motor resistor to the rear heater-A/C housing. Tighten the screw to 2 Nm (17 in. lbs.).
3. Connect the rear heater-A/CC wire harness connector (3) to the rear blower motor resistor.
4. Install the right rear quarter interior trim panel Quarter Trim Panel - Installation.
5. Reconnect the negative battery cable.