Removal - Front

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.





1. Disconnect and isolate the negative battery cable.
2. Remove the right front door scuff plate Description and Operation.
3. Remove the right cowl side trim panel.
4. Disconnect the wire harness connector (1) from the blower motor (2).
5. Remove the three screws (3) that secure the blower motor and blower wheel assembly to the HVAC housing (4).
6. Remove the blower motor and blower wheel assembly from the HVAC housing.