Front Evaporator Temperature Sensor - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE: Take the proper precautions to protect the front face of the instrument panel from cosmetic damage during this service procedure.





1. Disconnect and isolate the negative battery cable.
2. Remove the instrument panel assembly Instrument Panel - Removal.
3. Disconnect the HVAC wire harness connector (1) from the evaporator temperature sensor (2) located on the top of the HVAC housing (3) near the blend door actuator (4).
4. Remove the evaporator temperature sensor from the HVAC housing.