Oil Intake Control Valve - Installation

INSTALLATION

WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury Service Precautions





1. Install the oil control valve (OCV) (1).
2. Securely tighten the OCV fastener.
3. Connect the OCV electrical connector (2).
4. Install the intake manifold Intake Manifold - Installation





5. Connect the 12 volt battery system ground isolation connector (1) located next to the electric vacuum pump (2).
6. Perform the HEV high voltage power up procedure Battery System - High Voltage Power Up