Air Cleaner Body - Installation

INSTALLATION - AIR CLEANER HOUSING - HEV

WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury Service Precautions





1. Verify the throttle body seal is properly aligned at the bottom of the air cleaner housing.
2. Slide the rear air cleaner housing pegs (2) into the grommets (1) on the rear of the intake manifold and lower the front of the air cleaner housing onto the throttle body.






NOTE: Verify the air cleaner housing (3) is installed properly in the rear grommets by reaching around the left rear corner of the air cleaner and feeling for the pegs protruding through the rubber grommets. If the plastic pegs cannot be felt, the air cleaner will need to be reinstalled.

3. Install the air cleaner housing center fastener (2) and tighten to 7 Nm (62 in. lbs.).
4. Connect the intake air temperature (IAT) sensor electrical connector (1).





5. Install the center air cleaner housing trim cover (2).





6. Install the clean air tube (2).
7. Install the clean air tube fastener (3) and tighten to 7 Nm (62 in. lbs.).
8. Connect the high voltage inter lock (HVIL) electrical connector (1).





9. Connect the 12 volt battery system ground isolation connector (1) located next to the electric vacuum pump (2).
10. Perform the HEV high voltage power up procedure Battery System - High Voltage Power Up