Operation CHARM: Car repair manuals for everyone.
Home >> Dodge and Ram >> 2009 >> Durango 4WD V8-4.7L Flex Fuel >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Fuel Level Sensor >> Service and Repair >> Fuel Pump Module - Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Fuel Pump Module - Installation






INSTALLATION

CAUTION: Whenever the fuel pump module is serviced, the rubber seal (gasket) must be replaced.





1. Using a new seal (gasket), position the fuel pump module into the opening of the fuel tank.
2. Rotate the module until the embossed alignment arrow points to the center alignment mark. This step must be performed to prevent the float from contacting the side of the fuel tank. Also be sure the fuel fitting on top of the pump module is pointed to the left side of the vehicle.
3. Position the lock ring (5) over the top of the fuel pump module.
4. Position the lock ring remover/installer 9340 (3) into the notches on the outside edge of the lock ring (5).
5. Install a 1/2 inch drive breaker bar (1) into the lock ring remover/installer 9340 (3).
6. Tighten the lock ring (clockwise) until all seven notches have engaged.
7. Install the fuel tank Fuel Tank - Installation
8. Lower the vehicle.




9. Connect the fuel line quick connect fitting to the fuel rail (1)Service and Repair
10. Connect the negative battery cable.
11. Install the fuel fill cap.

pro multis · About Operation CHARM