Operation CHARM: Car repair manuals for everyone.
Home >> Dodge and Ram >> 2009 >> Durango 4WD V8-5.7L Hybrid >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Body Control Module >> Service and Repair >> Gateway Module - Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Gateway Module - Installation






INSTALLATION





1. Position the Hybrid Gateway Module (HGM) (1) near the Transmission Auxiliary Oil Pump (TAOP) control module mounting bracket (3) that is secured to the left hydro form (frame rail) near the back of the left front wheel house in the engine compartment.
2. Reconnect the two headlamp and dash wire harness connectors (4) to the HGM connector receptacles located on the forward facing side of the module.
3. Position the HGM to the TAOP control module mounting bracket.
4. Install and tighten the three screws (2) that secure the HGM to the mounting bracket. Tighten the screws securely.
5. Reinstall the Power Distribution Center (PDC) onto the PDC mounting bracket on the left hydro form over the left front wheel house in the engine compartment. Be certain that each of the PDC latches is fully engaged with the mounting bracket.
6. Reconnect the battery negative cable. A technician trained in proper Hybrid Electric Vehicle (HEV) service safety procedures must also reinstall the high voltage service disconnect into the high voltage battery pack.

pro multis · About Operation CHARM