Front Heater Core - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may result in accidental airbag deployment and possible serious or fatal injury. Air Bag(s) Arming and Disarming

WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation Warning and Caution. Failure to follow the warnings and cautions may result in serious or fatal injury. Service Precautions

WARNING: The heater core tubes are not serviced separately from the heater core. The heater core tubes should not be repositioned, loosened or removed from the heater core. Failure to follow this warning may result in a coolant leak and possible serious or fatal injury.

NOTE: LHD model shown in illustrations. RHD model similar.





1. Remove the HVAC housing and place it on a workbench .
2. Remove the A/C expansion valve A/C Expansion Valve - Removal.

NOTE: If the foam seal from the front of the HVAC housing is deformed or damaged, it must be replaced.

3. Remove the foam seal (1) from the front of the HVAC housing (2).
4. Remove the two screws (4) that secure the heater core cover (5) to the driver side of the air distribution housing (3).
5. Rotate and tilt the heater core cover as necessary to disengage the retaining tab that secures the front of the cover to the HVAC housing and remove the cover.






NOTE: If the foam seal around the heater core is deformed or damaged, it must be replaced.

6. Carefully pull the heater core (1) out of the driver side of the air distribution housing (2).