Pressure Hose

REMOVAL

1. Remove negative (-) battery cable from battery and isolate cable.
2. Remove cap from power steering fluid reservoir.
3. Using a siphon pump, remove as much power steering fluid as possible from power steering fluid reservoir.
4. Remove air cleaner housing cover and hose to intake manifold. Air Cleaner Body - Removal




5. Unthread tube nut and remove pressure hose (1) from pump (2).





6. Remove alternator bracket bolt (1).
7. Remove alternator bracket nut (2) and bracket (3).





8. Remove stud head screw (2) securing pressure hose (3) routing clamp to intake manifold (4).
9. Remove screw (1) securing pressure hose (3) routing clamp to right side of engine (5).

10. Raise and support vehicle. Service and Repair




11. Remove screw (2) securing pressure hose clamp to right side of front suspension crossmember.
12. Remove screws (3) securing pressure hose routing clamps to rear of front suspension crossmember.





13. Remove tube nut fastening pressure hose (4) to power steering gear (3). Remove pressure hose from gear port.

14. Lower vehicle enough to access pressure hose from engine compartment, but still clearing floor.
15. Remove pressure hose by pushing it down and out behind front suspension crossmember.