Installation

INSTALLATION





1. Install vapor canister (2).
2. Connect vapor canister quick connector (3) to fuel tank control valve.
3. Connect vapor canister quick connector (1) to vapor line.






WARNING: Support fuel tank with a transmission jack or equivalent. Use straps to secure the fuel tank to the jack. Failure to properly support and secure the fuel tank during removal may cause fuel to spill or fuel tank to fall from jack assembly.

4. Raise fuel tank into vehicle position.
5. Install vapor canister bracket bolt (1). Tighten to 54 Nm (40 ft. lbs.).
6. Tighten all fuel tank strap bolts (3) to 54 Nm (40 ft. lbs.).





7. Connect fresh air hose (3) to evaporative system integrity monitor (ESIM) switch (2).
8. Connect electrical connector (1) to ESIM switch (2).





9. Connect fuel line quick connect fitting (1) and evaporator hose quick connect fitting (2).





10. Connect body harness connector.





11. Install fuel fill hose and hose clamp (1) to fuel tank. Tighten clamp.
12. Install fuel cap.
13. Use the scan tool ASD Fuel System Test to pressurize the fuel system. Check for leaks.