Heater Pad - Installation

INSTALLATION






CAUTION: During the installation of the replacement heating element, be careful not to fold or crease the element assembly. Folds or creases will cause premature failure.

1. Peel off the adhesive backing from the replacement heater element (2) and stick on foam pad directly where the original heater element was placed (there will be adhesive marks on the foam outlining the factory installed element)(1).





2. Connect the new heater element electrical connectors (3AND4).
3. Connect the battery negative cable.
4. Verify heated seat system operation.
5. Install the appropriate seat cushion, Seat Cushion Cover - Installation or seat back trim cover, Seat Back Cover - Installation.

NOTE: Make certain the seat wire harness is correctly routed through the seat and seat back. The excess wire between the cushion and back elements should be securely tucked between the rear of the cushion foam and the rear carpet flap of the trim cover.