Cab/Chassis Models

CAB/CHASSIS MODELS





1. Install new gasket (1) to end of EGR tube.





2. Position EGR valve assembly (2) and two new gaskets to intake connection (3).
3. Install two EGR valve mounting bolts (1) and two nuts (1). Tighten four nuts/bolts finger tight only.





4. Install and lightly tighten two clamps (1) and (3) at ends of EGR Crossover Tube.
5. Install "P" clamp bolt (5) finger tight only.
6. Tighten clamp (1) first to 10 Nm. (7 ft. lbs.), then tighten clamp (3) to 10 Nm. (7 ft. lbs.).
7. Tighten "P" clamp bolt (5) to 10 Nm (7 ft. lbs.).





8. Tighten two EGR valve mounting bolts and two nuts (1) to 24 Nm (18 ft. lbs.). Tighten these four nuts/bolts in an alternating, criss-cross fashion.





9. Connect electrical connector (5) to EGR Actuator.










10. Install EGR crossover tube cover (1) and four bolts (2).





11. Install EGR valve heat shield (2). Tighten bolts/nuts to 10 Nm (7 ft. lbs.).
12. Connect both negative battery cables to both batteries.
13. Using a diagnostic scan tool, erase any previously recorded DTC's (Diagnostic Trouble Codes).