P0931

P0931-BTSI CONTROL CIRCUIT HIGH





For a complete wiring diagram, refer to the Wiring Information Electrical Diagrams.

- When Monitored:
With the ignition in the Unlock or Run position and the driver's foot applied to the brake pedal.

- Set Condition:
The Instrument Cluster detects a high value on the BTSI Solenoid Control circuit.





1. TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. Turn the ignition off, wait 10 seconds then turn the ignition on.
4. Apply and release the brakes.
5. With the scan tool, read DTCs.

Does the scan tool display: P0931-BTSI CONTROL CIRCUIT HIGH?

Yes

- Go To 2

No

- The condition that caused this code to set is not present at this time. Using the wiring diagram as a guide, inspect the wiring and connectors for an intermittent condition. Operate the system several times and recheck for active DTCs.
- Perform the BODY VERIFICATION TEST Body Verification Test.

2. CHECK THE (Z101) BTSI SOLENOID GROUND CIRCUIT FOR AN OPEN




1. Turn the ignition off.
2. Disconnect the BTSI Solenoid harness connector.
3. Measure the resistance between ground and the (Z101) BTSI Solenoid Ground circuit.

Is the resistance above 5.0 ohms?

Yes

- Repair the (Z101) BTSI Solenoid Ground circuit for an open.
- Perform the BODY VERIFICATION TEST Body Verification Test.

No

- Go To 3

3. CHECK THE (K32) BTSI SOLENOID CONTROL CIRCUIT FOR AN OPEN




1. Disconnect the Instrument Cluster C1 harness connector.
2. Measure the resistance of the (K32) BTSI Solenoid Control circuit between the BTSI Solenoid harness connector and the Instrument Cluster C1 harness connector.

Is the resistance above 5.0 ohms?

Yes

- Repair the (K32) BTSI Solenoid Control circuit for an open.
- Perform the BODY VERIFICATION TEST Body Verification Test.

No

- Go To 4

4. CHECK THE OPERATION OF THE BTSI SOLENOID




1. Reconnect the Instrument Cluster C1 harness connector.
2. Turn the ignition on.
3. Using a 12 volt test light connected to ground, check the (K32) BTSI Solenoid Control circuit.
4. With the scan tool, actuate the BTSI Solenoid.

Does the test light illuminate brightly?

Yes

- Replace the Transmission Unlock (BTSI)Solenoid.
- Perform the BODY VERIFICATION TEST Body Verification Test.

No

- Replace the Instrument Cluster.
- Perform the BODY VERIFICATION TEST Body Verification Test.