Tailgate

LAMP - TAILGATE






NOTE: This lamp is used on vehicles with a pick-up bed and dual rear wheels only. This lamp has a red lens, contains three bulbs and is located on the rearward facing surface of the pick-up bed sill panel below the tailgate.

1. Check to be certain that the two spring nuts (2) are properly installed and in good condition in the outer sill panel.
2. Position the marker lamp (3) to the outer sill panel.
3. Install and tighten the two screws (1) that secure the marker lamp lens/housing to the sill panel. Tighten the screws to 2 Nm (20 in. lbs.).
4. Reach under and behind the rear bumper near the center to access and reconnect the tailgate marker lamp pigtail wire connector (4) to the wire harness connector (5).
5. Reconnect the battery negative cable.