Transmission Range Sensor - Installation

INSTALLATION










1. Install the transmission range sensor (3) onto the control shaft (5).
2. Install the stake washer and the nut (4) and hand tighten.
3. With the transmission in neutral install the alignment tool 9983 (6) onto the control shaft (5) and into the alignment hole (1).
4. Install the bolts (2).
5. After aligning the transmission range sensor, tighten the bolts (2) 12.5 Nm (9 ft.lbs.)
6. Remove the alignment tool 9983 (6)
7. Tighten the control shaft nut to 7 Nm (62 in.lbs.)
8. Bend the tabs on the stake washer and nut (4) in at least two places to lock in position.




TRANSMISSION RANGE SENSOR





9. Install the manual shift lever (2) onto the control shaft.
10. Install the inner nut (3) onto the control shaft. Tighten the inner nut to 12.5 Nm (9 ft.lbs).
11. Install the outer nut (3) onto the control shaft. While holding the inner nut, tighten the outer not to 12.5 Nm (9 ft.lbs)