Operation CHARM: Car repair manuals for everyone.
Home >> Dodge and Ram >> 2009 >> Sprinter 2500 V6-3.0L DSL Turbo >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Fuel Pressure Sensor >> Service and Repair >> Fuel Pressure Sensor, Fuel Rail - Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Fuel Pressure Sensor, Fuel Rail - Installation






INSTALLATION





1. Install the sealing ring onto the sensor and screw the fuel pressure sensor into the fuel rail.
2. Tighten the senor to 60 Nm (44 ft. lbs.), back it off 90 degrees and retighten to 80 Nm (59 ft. lbs.).
3. Connect the sensor wiring harness connector.

CAUTION: Care must be taken when installing the engine cover. Assure the proper routing of the fuel injector return fuel hose to the banjo bolt fitting in the left rear corner of the cover. Failure to do so may pinch or damage the hose causing fuel leakage or a driveability concern.

4. Start engine, allow to run for a few minutes, turn the engine off and inspect for leaks.Warning - High Fuel System Pressure

pro multis · About Operation CHARM