Rear Exhaust Maniverter

INSTALLATION - REAR EXHAUST MANIVERTER, AWD





1. Clean the right maniverter gasket sealing surfaces with an appropriate tool Procedures.
2. Place the right maniverter in the engine compartment and position to allow installation of the maniverter lower heatshield (2).
3. Install the right maniverter lower heat shield (2) with heat shield retainers (1).





4. Install the right maniverter (6) and gasket (8) with retaining bolts (5). Tighten the bolts starting at the center working outward to 23 Nm (200 in. lbs.).
5. Install the right maniverter upper heat shield (4) with heat shield retainers (1), (2), and (3).





6. Install the intermediate shaft (4) and right half shaft Installation





7. Install the right maniverter upstream (4) and downstream (2) oxygen sensors and reconnect the harness connectors (1) and (3) Oxygen Sensor - Installation.





8. Install the exhaust crossunder pipe (3) Exhaust Cross under Pipe - Installation
9. Install the exhaust extension pipe (1) Exhaust Pipe - Installation





10. Install the right front tire and wheel assembly Tires and Wheels - Installation





11. Install the belly pan (2) and the twelve belly pan fasteners (1).
12. Lower the vehicle.
13. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).