Input Flange Seal - Removal

REMOVAL






NOTE: NOTE: Rubber coupler is part of the propeller shaft assembly. Removing coupler from propeller shaft will result in vibration/balance issues.

1. Raise vehicle on hoist.
2. Apply alignment index marks (4) on the rear axle flange (5) and rubber coupler (1).
3. Remove three rear propeller shaft rubber coupler to rear axle input flange retaining bolts (3).
4. Slide propeller shaft (2) back off rear axle input flange (5) and move out of the way as needed.





5. Using tool C-3281 (1), loosen input flange nut.










6. Remove input flange nut (1), and discard.










7. Remove input flange washer (1).





8. Using suitable puller (2), remove input flange (1).










9. Using suitable screwdriver (2), remove input flange seal from overrunning clutch housing.