Power Brake Booster - Installation

INSTALLATION










1. Guide the booster (2) studs into the cowl panel holes and seat the booster on the panel.
2. Install and tighten new booster attaching nuts (1) to 28 Nm (250 in. lbs.).

3. Install the booster push rod on brake pedal and install clip.

CAUTION: Do not reuse the original stop lamp switch. Anytime a switch has been removed or its position compromised, a new switch must be installed and adjusted. Do not attempt to readjust the switch.

4. Install a new brake lamp switch. Stop Lamp Switch - Installation.
5. Install the booster check valve if removed and connect the vacuum hose to the check valve.
6. Install the master cylinder. Brake Master Cylinder - Installation.
7. Fill and bleed the brake system. Service and Repair.