Front

INSTALLATION

Manual





NOTE: While servicing seat assemblies, Description and Operation

1. Position the cover (1) onto the foam and install 10 new hog rings (2).





2. Position the foam/cover assembly onto the seat cushion frame and secure the J-straps (1) on the sides.





3. Install the push pin fastener (3) and seat fully.
4. Install the recliner rod (1) and seat the retaining clip (2) fully.





5. Install the outer side shield and seat the clips (2) fully.
6. Install the screw (1).






NOTE: Power seat bezel shown, manual seat bezel similar.

7. Position the bezel (1) back into place and secure the front hook (2).
8. Seat the remaining clips (2) fully.





9. Install the clip (1) onto the recliner handle (2), if necessary.





10. Position the recliner handle (1) onto the splined shaft and seat fully.





11. Install the inboard shield (2) and install the screw (1).





12. Install the side shield screws (2) in the back.





13. Secure the seat back cover straps (2) to suspension mat.

Power Without Vented Seat





NOTE: While servicing seat assemblies, Description and Operation

1. Position the cover (1) onto the foam and install 10 new hog rings (2).





2. Position the foam/cover assembly onto the seat cushion frame and secure the J-straps (1) on the sides.





3. Connect the lumbar switch electrical connector (1), if equipped.





4. Install the outer side shield and seat the clips (2) fully.
5. Install the screw (1).





6. Install the inboard shield (2) and install the screw (1).





7. Install the side shield screws (2) in the back.





8. Secure the seat back cover straps (2) to suspension mat.





9. Position the switch bezel onto the outer side shield and connect the electrical connector (1).
10. Position the memory switch into the switch bezel and install the screws, if equipped.





11. Position the switch bezel (1) back into place and secure the front hook (2).
12. Seat the remaining clips (2) fully.

Power With Vented Seat





NOTE: While servicing seat assemblies, Description and Operation

1. Pull the vent pad (1) through the foam.





2. Position the cover (1) onto the foam and install 10 new hog rings (2).





3. Position the foam/cover assembly onto the seat cushion frame and secure the J-straps (1) on the sides.





4. Position the vented seat pad (2) onto the vent motor if equipped, and seat the clips fully.
5. Connect the electrical connectors, if equipped.





6. Connect the lumbar switch electrical connector (1), if equipped.





7. Position the switch bezel onto the outer side shield and connect the electrical connector (1).
8. Position the memory switch into the switch bezel and install the screws, if equipped.





9. Install the outer side shield and seat the clips (2) fully.
10. Install the screw (1).





11. Position the switch bezel (1) back into place and secure the front hook (2).
12. Seat the remaining clips (2) fully.





13. Install the inboard shield (2) and install the screw (1).





14. Install the side shield screws (2) in the back.





15. Secure the seat back cover straps (2) to suspension mat.
16. Install the recliner lever, if equipped.
17. Install the front seat. Service and Repair