Front

REMOVAL





1. Remove the front seat. Service and Repair
2. Separate the seat back cover straps (2) from under the seat cushion and disconnect the electrical connectors (1).





3. Remove the side shield screws (2) in the back.





4. Remove the inboard shield screw.
5. Remove the inboard side shield.





6. Using trim stick C-4755 or equivalent, release the six tabs (3) and separate the switch bezel (1) from the outboard side shield.
7. Pull the bezel (1) rearward and release the front retaining tab (2).





8. Disconnect the electrical connector (1).
9. Remove the screws (2) and remove the memory switch (4) from the switch bezel (3), if equipped.





10. Disconnect the lumbar switch electrical connector (1), if equipped and remove the switch bezel.





11. Remove the screw (1).
12. Release the retaining clips (2) and remove the outer side shield.





13. Release the seat cushion suspension mat (2) from the cross brace and separate the electrical connector (1).





14. On manual reclining seats, remove the clip (1) and separate the recliner rod (2) from the lever.





15. Remove the bolts (2) and remove the seat back assembly (1).