Front

REMOVAL

Manual





NOTE: While servicing seat assemblies, Description and Operation

1. Separate the seat back cover straps (2) from under the seat cushion.





2. Remove the side shield screws (2) in the back.





3. Remove the inboard shield screw (1).
4. Remove the inboard side shield (2).





5. Using a door handle clip tool (1) or equivalent, release the clip holding the handle (2) onto the seat and remove the handle.






NOTE: Power seat bezel shown, manual seat bezel similar.

6. Using trim stick C-4755 or equivalent, release the six tabs (3) and separate the bezel (1) from the side shield.
7. Pull the bezel (1) rearward and release the front retaining tab (2).





8. Remove the screw (1).
9. Release the retaining clips (2) and remove the outer side shield.





10. Separate the clip (1) and separate the recliner rod (2) from the lever.
11. Remove the push pin fastener (3).





12. Separate the cover J-straps (1) from the sides and remove the foam/cover assembly.





13. Remove the 10 hog rings (2) and separate the cover (1) from the foam.

Power Without Vented Seat





NOTE: While servicing seat assemblies, Description and Operation

1. Using trim stick C-4755 or equivalent, release the six tabs (3) and separate the switch bezel (1) from the side shield.
2. Pull the bezel (1) rearward and release the front retaining tab (2).





3. Disconnect the electrical connector (1).
4. Remove the screws (2) and remove the memory switch (4) from the switch bezel (3), if equipped.





5. Disconnect the electrical connectors (1), if equipped.
6. Separate the seat back cover straps (2) from under the seat cushion.





7. Remove the side shield screws (2) in the back.





8. Remove the inboard shield screw (1).
9. Remove the inboard side shield (2).





10. Remove the screw (1).
11. Release the retaining clips (2) and remove the outer side shield.





12. Disconnect the lumbar switch electrical connector (1), if equipped and remove the switch bezel.





13. Separate the cover J-straps (1) from the sides and remove the foam/cover assembly.





14. Remove the 10 hog rings (2) and separate the cover (1) from the foam.

Power With Vented Seat





NOTE: While servicing seat assemblies, Description and Operation

1. Remove the front seat assembly. Service and Repair
2. Disconnect the electrical connectors (1), if equipped.
3. Separate the seat back cover straps (2) from under the seat cushion.





4. Remove the side shield screws (2) in the back.









5. Using trim stick C-4755 or equivalent, release the six tabs (3) and separate the switch bezel (1) from the side shield.
6. Pull the bezel (1) rearward and release the front retaining tab (2).





7. Disconnect the electrical connector (1).
8. Remove the screws (2) and remove the memory switch (4) from the switch bezel (3), if equipped.
9. Separate the memory switch from the switch bezel (3), if equipped.





10. Remove the screw (1).
11. Release the retaining clips (2) and remove the outer side shield.





12. Disconnect the lumbar switch electrical connector (1), if equipped and remove the switch bezel.





13. Disconnect the vented seat bag (1) from the motor (2).
14. Disconnect the electrical connectors, if equipped.





15. Separate the cover J-straps (1) from the sides and remove the foam/cover assembly.





16. Remove the 10 hog rings (2) and separate the cover (1) from the foam.





17. Pull the vent pad (1) through the foam.