F. Replace Foot Actuator (ATC or MTC)

1. Disconnect the negative battery cable.

2. Remove the center bezel using the following procedure:

a. Remove the center bezel tray liner (Figure 2).

b. Remove the power outlet trim bezel.

c. Remove the three center bezel mounting screws.

d. Unsnap the center bezel from the instrument panel, disconnect the electrical connectors and remove the center bezel.

3. Remove the cup holder using the following procedure:

a. Remove the lower cup holder trim panel.

b. Remove the six cup holder mounting screws.

c. Remove the cup holder assembly and side panels.

4. Disconnect the foot actuator electrical connector (Figure 3).

5. Remove and discard the original foot actuator (Figure 3).

6. Install the new foot actuator into position on the heater housing.

7. Install the foot actuator electrical connection (Figure 3)

8. Install the foot actuator mounting screws. Tighten the screws to 9 in. lbs. (1 N.m).

9. Install the cup holder using the following procedure to:

a. Place the cup holder assembly and side panels into position.

b. Install the six cup holder mounting screws. Tighten the screws securely.

c. Install the lower cup holder trim panel.

10. Connect the electrical connectors to the center bezel.

11. Snap the center bezel into position.

12. Install the three center bezel mounting screws.

13. Install the power outlet trim bezel.

14. Install the center bezel tray liner.

15. If no other actuators require replacement, continue with Section G. Actuator Calibration.

If the actuator test determined there are additional actuator(s) that require replacement, continue with the appropriate Section in this document to replace the actuator(s) that have active DTC's.