Brake Master Cylinder - Installation

INSTALLATION

NOTE: Bleed new master cylinder on bench before installation.





1. Position the master cylinder (1) to the power brake booster, install the two master cylinder retaining nuts (3) and tighten to 25 Nm (18 ft. lbs.).
2. Install the brake lines (4) at the master cylinder (1) and tighten to 19 Nm (168 in. lbs.).





3. Connect the wire connector (2) to the fluid level sensor (3).






NOTE: Make sure the tab (4) is snaps into place.

4. Position the cowl side extension (5) and install the cowl side extension to cowl extension fastener (1).
5. Install the hood weather strip (2) into position and attach the connector (3) to the body.
6. Fill and pressure bleed the brake system Service and Repair.