Parking Brake Lever - Installation

INSTALLATION





1. Position the parking brake lever assembly, install the retainer bolts/nuts (1) and tighten to 24 Nm (18 ft. lb.).
2. Connect the wiring harness connector to the parking brake switch (2).
3. Attach the instrument panel wiring harness connector to the parking brake assembly harness retainer clip (3).





4. Install the front cable end (1) into the brake lever assembly (3).





5. Install the front cable housing (3) to the bracket (1).
6. Raise and support the vehicle Maintenance.





7. Connect the right rear and left rear parking cables (2, 5) to the equalizer (1).
8. Remove the supports and lower the vehicle.
9. Remove the lockout of the parking brake assembly Service and Repair.
10. Install the side cowl trim panel Cowl Trim Panel - Installation.