Floor Console Duct - Installation

INSTALLATION

FRONT DUCT

NOTE: Take the proper precautions to protect the floor console from cosmetic damage while performing this procedure.






NOTE: If the foam seal on the console rear duct is deformed or damaged, the seal must be replaced.

1. Position the floor console front duct (2) to the floor console and connect it to the rear duct (3).
2. Install the four push-pin retainers (1).
3. Install the floor console Floor Console - Installation.
4. Reconnect the negative battery cable.

REAR DUCT

NOTE: Take the proper precautions to protect the floor console rear trim panel from cosmetic damage while performing this procedure.





1. If required, position the air outlet barrel(s) (1) into the console rear duct (2) and gently push the barrel(s) into the duct, until the barrel snaps into position on the pivot shafts. Make sure each barrel is square in the duct opening and moves freely on the pivot shafts.






NOTE: If the foam seal on the console rear duct is deformed or damaged, the seal must be replaced.

2. Install the floor console rear duct (2) onto the floor console rear trim panel (4).
3. Install the six screws (1 and 3) that secure floor console rear duct to the floor console rear trim panel. Tighten the screws securely.
4. Install the floor console rear trim panel (1) onto the back of the floor console. Be sure to connect any necessary electrical connectors and properly align the console ducts.
5. Reconnect the negative battery cable.