Rear

REAR WHEEL STUD

1. Install the three washers onto the stud, then install the lug nut with the flat side of the nut against the washers.
2. Tighten the lug nut until the stud is pulled into the hub flange. Verify that the stud is properly seated into the flange.
3. Remove the lug nut and washers.
4. Install a new bearing into the knuckle and install the hub Rear Hub And Bearing - Installation.
5. Install the wheel and tire assembly, use new lug nut on stud or studs that were replaced Service and Repair.
6. Remove the support and lower vehicle.