Engine Coolant Temperature Sensor - Removal
3.6L ENGINE
The Engine Coolant Temperature (ECT) sensor on the 3.6L engine is installed into a water jacket at rear of the cylinder head on the left side of the engine.
WARNING: Hot, pressurized coolant can cause injury by scalding. Cooling system must be partially drained before removing the coolant temperature sensor.
NOTE: Do not waste reusable coolant. If solution is clean, drain coolant into a clean container for reuse.
1. Partially drain the cooling system.Service and Repair
2. Disconnect the electrical connector from the sensor.
3. Remove the sensor from the cylinder head.