Third Row

THIRD ROW

CENTER (INBOARD)

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.






NOTE: The two center buckles and their anchor bracket are serviced only as a complete unit. If one center buckle is ineffective, both center buckles and the anchor bracket must be replaced.

1. Working from behind the third row seat, fold the hinged cargo floor filler panels rearward for access to the seat center bracket (4).
2. Disengage the two plastic push-in fasteners at the rear and the two integral retainers of the seat center hinge trim cover (1) and remove the cover from over the center buckle stanchions between the seat cushions.
3. Remove the screw (3) that secures the center buckle anchor bracket (2) to the seat center bracket.
4. Disengage the T-tab of the center buckle anchor bracket from the T-slot of the seat center bracket.
5. Working from in front of the third row seat, remove the two center buckles and the anchor bracket as a unit from between the seat cushions.

LOWER ANCHOR (OUTBOARD)

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.





1. Disengage the third row seat belt (1) anchor latch plate from the lower anchor buckle (2).
2. Remove the screw that secures the anchor plate of the lower anchor buckle to the floor panel.
3. Remove the lower anchor buckle from the vehicle.