Rear Camber Link - Installation

INSTALLATION






CAUTION: The camber links (2) are left/right specific but could be installed incorrectly. Be sure that the bushing bevel is located at and against the knuckle, and that the camber link (1) curves down in the center when installed.

1. Position the camber link (2) and install the link to knuckle bolt/nut (1). Do not tighten.
2. Install the camber link to cradle cam bolt/nut (3). Do not tighten.
3. Connect the speed sensor clips to the camber link (2).
4. Using a suitable holding fixture, support the outboard end of the lower control arm and lift it to normal ride height.
5. Tighten the camber link to knuckle bolt/nut (3) to 110 Nm (81 ft. lbs.).

NOTE: Position the cam as close to removal marking as possible to aid in alignment.

6. Tighten the camber link to cradle cam bolt/nut (1) to 93 Nm (68 ft. lbs.).
7. Remove the lower control arm holding fixture.
8. Install the wheel Service and Repair.
9. Remove the supports and lower the vehicle.
10. Perform an alignment Wheel Alignment Procedures